Siemens SE505 - Manual (Page 9)

8
The Gigaset SE505 dsl/cable
Gigaset SE505 dsl/cable / English / A31008-E505-B100-1-7619 / introduction.fm / 16.07.2003
Procedure for installation and configuration
1. First install an Ethernet network card or a wireless Network adapter such as the
Gigaset PCI Card 54 or Gigaset PC Card 54 in the PC's you want to connect with the
Gigaset SE505 dsl/cable. The installation procedure can be found in the product's
User Guide.
2. Now install the router (refer to the section entitled "Installing the Gigaset SE505 dsl/
cable" on page 13).
3. Before the PC's can communicate with the router and with each other in a local
network, you have to change their network settings. Configure these network
settings on one PC first so that it can establish a connection to the router. You can
then use that PC to configure the router. To find out how to do this, refer to
"Configuring the local network" on page 18.
4. In a wireless connection you establish the link from the PC's wireless network
adapter to the router. This is described in the network adapter's operating
instructions.
5. Now configure the router to activate the router's Internet access (refer to the section
"General configuration with Basic Setup" on page 52).
This will require the access data from your Internet Service Provider.
6. If you want to connect more PC's to the router, configure their network settings to
set up the local network (refer to the section entitled "Configuring the local network"
on page 18).
7. If you wish to use the router's other functions, e.g. the comprehensive security
features, use the router's Security Setup (see page 63) or Advanced Setup (see
page 70).
i
When installing wireless network adapters you should note the
following:
The default
SSID of the Gigaset SE505 dsl/cable is ConnectionPoint.