Siemens SE505 - Manual (Page 72)

71
Configuration with Advanced Setup
Gigaset SE505 dsl/cable / English / A31008-E505-B100-1-7619 / configure_router.fm / 16.07.2003
◆ Transmission mode
The transmission mode indicates whether the wireless transmission complies with
IEEE Standard 802.11b or IEEE 802.11g, or whether both transmission modes are
possible (Mixed mode). The main difference between the two standards is the
Transmission rate: IEEE 802.11b – maximum 11 Mbps, IEEE 802.11g – maximum
54 Mbps. If the units use different standards in the wireless network, then you
should leave the default Mixed mode.
◆ Transmission rate
The transmission rate depends on the selected transmission mode. The possible
transmission rates are shown in the pick list. You should leave the default set to
Auto.
◆ Click on APPLY to apply the settings.
Setting the Encryption
If you are sending sensitive data over wireless channels, we recommend that you
activate WEP - Encryption on your wireless network components.
To activate WEP encryption on your wireless network components:
1. Activate Web encryption on your Gigaset SE505 dsl/cable and generate a 64 or 128
bit key. Make a note of the generated key.
2. Activate WEP encryption on the wireless network adapters and enter the generated
64 or 128 bit key.
You can choose either the standard 64 bit key or the more robust 128 bit key for
encryption. The keys are generated in hexadecimal format. You must use the same keys
for encryption and decryption for the Gigaset Router and all your wireless network
adapters.
i
Wired Equivalent Privacy (WEP) protects data transmitted between
wireless nodes. However WEP does not protect transmission on your
wired network or over the Internet.
i
You will find a detailed example of how to set up WEP encryption in
"Practical Tips and Configuration Examples" on the CD supplied.