Siemens SE505 User Manual

Page 36

Configuring the local network

Gigaset SE505 dsl/cable / English / A31008-E505-B100-1-7619 / configure_tcpip.fm / 16.07.2003

Synchronising the TCP/IP settings with the Gigaset SE505 dsl/cable

You have now configured your computer so that it is ready to be connected to the

Gigaset SE505 dsl/cable. You now have to release the old TCP/IP settings and

synchronise them with the settings of your Gigaset SE505 dsl/cable.

◆

Click on Start on the Windows Desktop and then Programs, followed by

Accessories and finally Command prompt.

◆

In the Command prompt window enter the ipconfig /release command and

press the ENTER KEY.

◆

Then enter the IPCONFIG /RENEW command and press the ENTER KEY.

If the router's default IP address (192.168.2.1) was not changed, the IP address

should now read 192.168.1.x (x being a number between 2 and 254). The Subnet

Mask must always be 255.255.255.0 and the Default Gateway must have the

router's IP address (192.168.2.1). These values confirm that your Gigaset SE505 dsl/

cable is working.

◆

Enter EXIT and press the Enter Key to close the Command prompt window.