Sun Microsystems 4500/3 - Manual (Page 55)

Chapter 2 The Cluster Platform 4500/3 System 43
■
Ethernet addresses
Note – Because the recovery results in a generic, unconfigured system, you must
restore all site-specific configuration files from backup. If your site uses special
backup software such as VERITAS NetBackup, you must reinstall and configure that
software.
Recovery CD-ROMs
■ CD0: Cluster Platform 4500/3 Recovery Environment Boot CD
Contains a bootable copy of the Solaris 8 10/00 Operating Environment,
configured to execute recovery software
■ CD1: Cluster Platform 4500/3 Recovery Operating System CD 2
Installs software for the Solaris operating environment, Solstice DiskSuite, Sun
Cluster 3.0, and recommended patches.
■ CD2: Cluster Platform 4500/3 Node Software Operating System CD.
Contains software for the Cluster Environment to jump-start the nodes for
performing mirroring and hotsparing. Installs the Solaris operating environment
and recommended patches onto each node.
Contains information to build the management server and loads the mirroring
script.
▼ Installing the Recovery CD
1. Access the management server console through the terminal concentrator:
2. To issue a Stop-A command to the cluster nodes and to access the OpenBoot
PROM (OBP) prompt, position the cursor in the Cluster Console window and
enter the <
ctrl>] character sequence.
# telnet sc3sconf1-tc
Trying 148.212.87.62...
Connected to sc3sconf1-tc.
Escape character is ’^]’
Rotaries Defined:
cli
Enter Annex port name or number: 1