Sun Microsystems 4500/3 User Manual

Page 33

Chapter 2

The Cluster Platform 4500/3 System

6. Terminate your tip session by entering

~ .

(tilde and period). Power-cycle the

terminal concentrator to enable the IP address changes and wait at least two
minutes for the terminal concentrator to activate its network.

Note –

Double-check to ensure that the Ethernet hub is connected to the local area

network. An RJ-45 cable must connect the Ethernet hub to the administration
network backbone.

a. Disconnect the RJ-45 serial cable (Part No. 5121A) from Port 1 of the terminal

concentrator and from the Sun workstation.

b. Reconnect the serial cable (Part No. 9524A) back into Port 1 of the terminal

concentrator.

Note –

At this time, the cluster configuration should be cabled as originally shipped

from the factory.

7. From the Sun workstation, verify that the terminal concentrator responds to the

new IP address:

Note –

The Sun workstation must be connected to the same subnet to which the

terminal concentrator was configured.

monitor:: ~ .

# usr/sbin/ping -I

5 148.212.87.62

PING 148.212.87.62: 56 data bytes

64 bytes from scotch (148.212.87.62): icmp_seq=0. time=1. ms

64 bytes from scotch (148.212.87.62): icmp_seq=1. time=0. ms

64 bytes from scotch (148.212.87.62): icmp_seq=2. time=0. ms

64 bytes from scotch (148.212.87.62): icmp_seq=3. time=0. ms