Sun Microsystems 4500/3 - Manual (Page 39)

Chapter 2 The Cluster Platform 4500/3 System 27
16. Select Dynamic Host Configuration Protocol (DHCP) services.
Because the management server must have a fixed IP address and name recognized
by outside clients, DHCP is not supported:
17. Select the primary network interface.
The management server configuration uses eri0 as the default primary network
interface:
On this screen you must specify whether or not this system should
use DHCP for network interface configuration. Choose Yes if DHCP
is to be used, or No if the interfaces are to be configured
manually.
WARNING: Because this machine booted from the network, DHCP support
will not be enabled, if selected, until after the system reboots.
Use DHCP
--------
[ ] Yes
[X] No
2
On this screen you must specify which of the following network
adapters is the system’s primary network interface. Usually the
correct choice is the lowest number. However, do not guess; ask
your system administrator if you’re not sure.
> To make a selection, use the arrow keys to highlight the option
and
press Return to mark it [X].
Primary network interface
-------------------------
[X] eri0
[ ] eri1
2