Samsung SCX-6320F - Manual (Page 219)

I NSTALLING O PTIONS
D.10
4
Press the scroll buttons until “Manual” displays on the
bottom line. Press Enter to access the menu.
5
Press the scroll buttons to select IP Address, Subnet Mask,
GateWay, Primary DNS, Secondary DNS or LDP/LPR Raw
Printing HTTP on the bottom line.
6 Press Enter to set an address.
A TCP/IP address consists of 4 bytes.
7 Enter a number between 0 and 255 for each byte and press
Enter.
You can move between each byte by pressing the scroll
buttons.
8 Repeat steps 4 through 5 to configure the other TCP/IP
parameters, such as subnet mask and gateway.
9 When you are finished, press Stop/Clear.
Dynamic Addressing (BOOTP/DHCP)
To allow the server to automatically assign the TCP/IP address,
take the following steps:
1 Refer to steps from 1 to 3 on page D.9.
2 Press the scroll buttons to select the server to assign the
TCP/IP address, DHCP or BOOTP. Press Enter to save the
selection.
3
When you are finished, press Stop/Clear.
Enter a number between 0
and 255 for each byte.