Sun Microsystems 220R - Manual (Page 97)

3.4 How to Install a PCI Card
3.4.1 Before You Begin
Complete these tasks:
4 Section 2.1 “How to Power Off the System” on page 54
4 Section 2.4 “How to Position the System for Service” on page 60
4 Section 2.6 “How to Remove the System Cover” on page 65
4 Section 2.8 “How to Avoid Electrostatic Discharge” on page 69
Read the documentation supplied with the PCI card for information about jumper
settings, PCI slot requirements, and cable connections.
For information about the system’s PCI slots and locations, see Section C.1.2 “PCI
Bus” on page 253.
3.4.2 What to Do
1. If you are installing a PCI card in an unused slot, remove the corresponding
filler panel from the back of the system. Otherwise go to Step 2.
a. Remove the Phillips screw that secures the PCI filler panel to the system
back panel.
b. Lift out the filler panel.
Servicing the Main Logic Board and Components 97