Sun Microsystems 220R - Manual (Page 172)

2. Insert the cutout end of the DC-to-DC converter board into the slots on the
metal tabs in the chassis.
Insert the DC-to-DC board into the metal slots at an angle so that the post holes
on the back of the converter board align with the plastic retaining clip posts.
3. Lower the DC-to-DC converter onto the plastic retaining clips.
Ensure that the other end of the DC-to-DC converter board remains in place in
the metal tabs.
4. Secure the DC-to-DC converter board in place.
Push down on the board until the plastic tabs secure the board in place.
172 Sun Enterprise 220R Server Service Manual
♦
January 2000, Revision A