3 what next – Sun Microsystems 220R User Manual
Page 161
6. Pull out the power supply in a smooth motion until the unit is free of the bay.
Note -
When removing a hot-pluggable power supply, do not disengage and
reengage the supply in rapid succession.
7. If you have removed a redundant power supply and are not replacing it
immediately, install a power supply filler panel.
The filler panel maintains proper system cooling and prevents electromagnetic
interference. Align the filler panel over the empty bay and push it into place.
8. Tighten the Phillips screw on the power supply retaining clip.
6.1.3
What Next
To replace a power supply, complete this task:
4
Section 6.2 “How to Install a Power Supply” on page 162
Removing and Replacing Miscellaneous Assemblies
161