SMC Networks EliteView 6.20 - Manual (Page 220)

E
RROR
M
ESSAGES
I-28
Cause: Out of memory.
Action: Close some applications and retry, or restart Windows.
No usable WinSock.dll found.
Cause: The WinSocket network subsystem failed. Verify the platform.
Action: Check the network subsystem.
Open UDP socket failed with error code = %d.
Cause: An Open Socket operation failed. The error code comes from the function socket( ) of the WinSocket API.
Action: Check the network subsystem by error code.
Receive frame from wrong socket %d.
Cause: The Receive process in winsock.dll had an error.
Action: Check the network subsystem.
Send packet failed with error code %d.
Cause: The network subsystem has a problem. The error code comes from function sendto( ) in the WinSocket
specification.
Action: Check the network subsystem by error code.
Setup received message error - error code = %d.
Cause: Cannot setup a Windows message for received frames. The error code comes from the WSASelect( )
function in the WinSocket specification.
Action: Check the network subsystem by error code.
The network subsystem is not ready.
Cause: The network subsystem may not be the correct platform.
Action: Verify the platform.
The port number of application is duplicate.
Cause: Two client programs are using the same port number for the IP protocol. Some TFTP application may not
have quit normally.
Action: Check your applications.
The slot is saturated.
Cause: TFTP.DLL can only support 10 sessions.
Action: Never open more than 10 sessions.
The windows socket’s version specified by application is not supported by this winsock.dll.