SMC Networks EliteView 6.20 - Manual (Page 169)

I
NSIDE THE
TRAP.INI F
ILE
B-13
4=1,Trap, Authentication Failure
5=1,Trap,egpNeighborLoss
From the [generic] section, you can view the following data:
• Trap number 0
• It is active (1)
• It triggers the “Trap” event
• When invoked the message “Cold Start” will be displayed in the event message box
The [enterprise] Section
This section lists and defines all enterprises used in the program. Enterprises are object identifiers used in generic
and specific traps.
To edit the [enterprise] section:
1. Edit the total=n line to specify the total number of available enterprises. The variable n is a positive number
that specifies the number of items listed under this menu.
2. Add a line describing each item in the [enterprise] section using the following format:
i=Active_Flag,Enterprise_ID,Number_of_Traps
The table below describes each parameter:
Example: Sample entry for [enterprise] section
[enterprise]
total=1
1=1,1.3.6.1.4.1.259,15
From the [enterprise] section, one can read the following information:
• The entry defines a single enterprise (total=1)
• The enterprise is active with object identifier equal to 1.3.6.1.4.1.259
• This enterprise defines 15 traps
Table B-13 Parameters of the [enterprise] Section
Parameter Description
i= The sequence number is from 1 to n, where n is the total number of enterprises.
Active_Flag Select either 0 or 1, where 1=Active and 0=Disabled.
Enterprise_ID The object identifier of the enterprise.
Number_of_Traps Number of specific traps defined for this enterprise.