Sharp AR-507 - Manual (Page 79)

3-45
CHAPTER
3
SPECIAL FUNCTIONS
Tandem copy
5 Press the “OK” key.
6 Make all other desired copier settings and enter the
number of copies.
● The functions selected on the main copier will be used by both copiers.
(1) The key operator programs of which settings at the main copier
are given priority (the settings at the sub copier are disregarded):
Exposure Adjustment, Toner Save Mode, Initial Margin Shift,
Erase Width Adjustment, Initial Status Setting, Staple Position
Setting, Date Format Setting, Date and Time Adjustment and
Disabling of Covers Mode.
(2) The key operator programs for which the same settings
between the main and sub copiers are required:
Disabling of Duplex Copying and Disabling of Stapler.
(3) The key operator program that can only be set at the main copier:
Disabling of Auto Paper Selection.
(4) In case of the other key operator programs than mentioned
above, different settings on the main and sub copiers
respectively do not matter even when the tandem copying is
activated.
7 Ensure that paper of the same size selected in the main
copier is installed in the sub copier.
● Paper of the same size and same orientation must be installed
in the two copiers. Even if the image of the original is rotated to
match the copy paper in the main copier, the orientation of the
copy paper in the sub copier must be the same as that in the
master copier.
8 On the main copier, press the START ( ) key.
● Images scanned by the main copier will be stored in both copiers.
Half the number of copies selected will be made simultaneously
on both copiers. When the number of copies selected is odd, one
more copy will be made on the main copier than the sub copier.
● If the message “ CHECK THE SUB MACHINE. ” appears on the
main machine, an error has occurred in the sub machine. Check
the message on the sub machine and clear the error.
● If the message “ THE SYSTEM IS NOT CONFIGURED TO
PERFORM TANDEM JOB. CODE: XX ” appears on the main
machine, refer to the tandem copy related descriptions in the
TROUBLESHOOTING (see page 5-15).
● To cancel a copy run after starting, press the CLEAR ALL ( CA )
key on the main copier.
● To cancel the TANDEM copying, press the “TANDEM COPY”
key again on the SPECIAL MODES screen of the main copier.
1 2 3
4 5 6
7 8 9
0
C
P
CLEAR
PROGRAM AUDIT CLEAR
INTERRUPT
C
CLEAR
INTERRUPT
CA
CLEAR ALL
START
TANDEM COPY
TRANSPARENCY
INSERTS
DUAL PAGE
COPY
OK