Sharp AR-507 - Manual (Page 120)

7-6
CHAPTER
7
Staple sort
The STAPLE SORT mode staples A4, A4R, B4, and A3 (8-1/2" x 11", 8-1/2" x
11"R, 8-1/2" x 14", and 11" x 17") size copies. Stapled sets cannot be delivered to
the top tray.
● In the STAPLE SORT mode, copying will automatically stop when the number
of copies output in the offset tray exceeds certain limits regardless of the tray
capacity. In that case, follow the message on the screen. Such limits vary with
the size of copy paper.
NOTE:
Different size originals cannot be copied onto copy paper of their respective sizes
in the STAPLE SORT mode. The paper size selected for the first scanned original
will be used for all originals. To copy different size originals in the STAPLE SORT
mode, select the paper size for the largest original.
Using the RSPF
1 Set the originals in the document feeder tray.
● If the number of copies in one set is more than 50 for
A4 or A4R (8-1/2" x 11" or 8-1/2" x 11"R) paper or 25 for B4 or
A3 (8-1/2" x 14" or 11" x 17") paper, the copies will not be
stapled.
● The stapling position shown in the left figure is the factory de-
fault position.
2 Press the OUTPUT key.
3 Press the “STAPLE SORT” key on the touch panel.
OPTIONAL EQUIPMENT
Finisher (AR-FN3)
FINISHER (AR-FN3)
AUTO
EXPOSURE
Stapling position
READY TO COPY.(DOCUMENT FEEDER MODE)
OUTPUT
TOP TRAY
OFFSET
SORT OFFSET
TRAY
STAPLE
SORT GROUP
OK
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO A4