Sharp AR-507 - Manual (Page 171)

8-31
CHAPTER
8
KEY OPERATOR’S GUIDE
Key Operator assistance call
KEY OPERATOR ASSISTANCE CALL
When the copier is in need of service or care not usually performed
by general users, the copier will stop and one of the following
messages listed below will appear.
Message Remedy
CHECK STAPLER POSITION OR STAPLE JAM. See page 7-12 for staple jam removal. If the trouble cannot
be easily remedied, use key operator program
“DISABLING OF STAPLER” (page 8-28) to prevent the use
of the stapler.
Contact your authorised Sharp Service Centre for service.
THE FINISHER IS OUT OF SERVICE. Contact your authorised Sharp Service Centre for service.
PRESS [CA] TO CANCEL JOB. (This message will appear when an optional finisher (AR-
FN3) malfunctions.)
DUPLEX SYSTEM IS OUT OF SERVICE. Use key operator program “DISABLING OF DUPLEX
COPYING” (page 8-27) to prevent the use of the duplex
system. Contact your authorised Sharp Service Centre for
service.
THE DOCUMENT FEEDER IS OUT OF SERVICE. Use key operator program “DISABLING OF DOCUMENT
PRESS [CA] TO CANCEL JOB. FEEDER” (page 8-27) to prevent the use of the document
feeder. Contact your authorised Sharp Service Centre for
service.
SELECTED PAPER TRAY IS OUT OF SERVICE. Contact your authorised Sharp Service Centre for service.
PLEASE SELECT ANOTHER PAPER TRAY.
CALL FOR SERVICE. CODE: With this message, an alphanumeric code will appear to
indicate a malfunction has occurred which cannot be
corrected by the key operator.
Contact your authorised Sharp Service Centre for service.
Be sure to report the alphanumeric code information as
well. This will enable the Service Centre to prepare to
correct the malfunction associated with the code.