Sharp AR-507 - Manual (Page 169)

8-29
CHAPTER
8
To require key operator code entry for access to key operator
programs, press the check box of “DISABLING OF PC/
MODEM ACCESS.” to display a check mark in the check box.
To permit remote access to key operator programs without
key operator code entry, press the check box of this program
again to clear the check mark in the check box.
NOTE:
The customers must choose the setting of this program by themselves.
If this program is not set, external operators can access the key
operator programs from a computer or other equipment without key
operator code entry. If this program is set, external operators must
enter the key operator code to access the key operator programs. (This
program is set in the factory default setting.)
Disabling of Auto Power Shut-off Mode
The auto power shut-off mode is used to turn off the power automatically
once a programmed length of time has elapsed without any copier
operation after the last copy of a run is made or power is turned on. This
mode lowers the user’s electricity bill, reduces waste of natural
resources, and cuts down on environmental pollution.
Depending on how the machine is to be used, you may wish for some
reasons to disable this mode. This can be done using this program.
NOTE:
Since we would like you to fully understand the purpose of this mode,
we suggest that you enable this mode and set the most appropriate
time using program “AUTO POWER SHUT-OFF TIMER” (page 8-23).
To disable the auto power shut-off mode, press the check
box of “DISABLING OF AUTO POWER SHUT-OFF MODE.” to
display a check mark in the check box.
To restore the mode, press the check box of this program
again to clear the check mark in the check box.
Disabling of Beep When Keys Touched
This program is used to enable or disable the beep function. If this
function is enabled, a beep sound will be produced when you press a
key on the operation panel including the touch panel.
To disable the beep function, press the check box of
“DISABLING OF BEEP WHEN KEYS TOUCHED.” to display
a check mark in the check box.
To enable the beep function, press the check box of this
program again to clear the check mark in the check box.
KEY OPERATOR PROGRAMS
KEY OPERATOR’S GUIDE
Key operator programs