Sharp AR-507 - Manual (Page 167)

8-27
CHAPTER
8
Disabling Deletion of Job Programs
This program is used to prevent stored programs from being replaced
or deleted. If this program is set, storing of job programs is also
disabled.
To prevent job programs stored in memory from being
replaced or deleted, press the check box of “DISABLING
DELETION OF JOB PROGRAMS.” to display a check mark in
the check box.
To allow replacement/deletion, press the check box of this
program again to clear the check mark in the check box.
Disabling of Document Feeder
This program is used to prevent the use of the document feeder when
it malfunctions.
To prohibit use of the document feeder, press the check box
of “DISABLING OF DOCUMENT FEEDER.” to display a check
mark in the check box.
To enable use of the document feeder, press the check box
of this program again to clear the check mark in the check
box.
Disabling of Duplex Copying
This program is used to enable or disable the duplex system. If a
malfunction occurs within the duplex system of the copier, the system
can be disabled until it is serviced. The rest of the copier in the
meantime will remain operable.
To disable the duplex system, press the check box of
“DISABLING OF DUPLEX COPYING.” to display a check
mark in the check box.
To enable the duplex system, press the check box of this
program again to clear the check mark in the check box.
KEY OPERATOR PROGRAMS
KEY OPERATOR’S GUIDE
Key operator programs