Sharp AR-507 User Manual
Page 124
7-10
CHAPTER
7
Staple cartridge replacement
The message “
SLIDE THE FINISHER AWAY FROM THE COPIER
AND ADD STAPLES.
” will appear when the staple cartridge is empty.
Replace the staple cartridge as follows:
1
While holding the finisher release lever, slide the finisher
away from the copier.
2
Lower the lock lever to unlock the stapler unit.
3
Turn the stapler unit to face up.
4
Hold the staple box release lever to unlatch the staple
box.
5
Remove the staple box.
6
Remove the empty staple cartridge from inside the
staple box.
7
Insert the new staple cartridge into the box until it clicks
in place.
●
Insert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
●
The cartridge holds 5,000 staples.
OPTIONAL EQUIPMENT
Finisher (AR-FN3)
FINISHER (AR-FN3)