Sharp AR-507 - Manual (Page 142)

8-2
CHAPTER
8
KEY OPERATOR CODE NUMBER
Registering the key operator code number
1 Press the CUSTOM SETTINGS ( ) key.
2 Press the “KEY OPERATOR PROGRAMS” key on the
touch panel.
● The following display will appear.
3 Enter your key operator code number using the 10-key
pad.
● When registering the key operator code number for the first time,
enter the number that was set at the factory. (See page 8-33.)
● As the code number is entered, the dashes in the display will
change to asterisks.
4 Press the “COPIER” key on the touch panel.
5 Press the “OTHER FUNCTION SETTINGS” key.
6~200 g /m 2
CUSTOM SETTINGS
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO A4
EXIT
DISPLAY
CONTRAST KEY OPERATOR
PROGRAMS
KEY OPERATOR PROGRAMS EXIT
COPIER
TOTAL COUNT.
PROGRAM LIST
PRINTOUT.
COPIER PDA/ZR
KEY OPERATOR PROGRAMS
COPIER MODE
OTHER FUNCTION
SETTINGS
ENABLE/DISABLE
SETTINGS
TIMER SETTINGS
ACCOUNT CONTROL
OK
KEY OPERATOR PROGRAMS
ENTER KEY OPERATOR CODE.
EXIT
KEY OPERATOR CODE
- - - - -
A key operator code number must be registered before a key operator
program can be used. The key operator must remember this number. Only
this registered number will allow access to the key operator programs.
1 2 3
4 5 6
7 8 9
0
C
P
CLEAR
PROGRAM AUDIT CLEAR
INTERRUPT
KEY OPERATOR’S GUIDE
Key operator code number