Sharp AR-507 - Manual (Page 112)

6-8
CHAPTER
6
GENERAL INFORMATION Specifications
COPIER
Type Desktop
Copy system Dry, electrostatic transfer system
Originals Sheets, bound documents
Original feed system Reversing single pass feeder (RSPF)
Original sizes Max. A3 (11" x 17")
Copy sizes Max. A3 (11" x 17"), min. A6 (5-1/2" x 8-1/2")
Image loss:
Max. 5 mm (13/64")
(both leading and trailing edges)
Max. 5 mm (13/64")
(along all other edges in total)
For paper weight, see page 4-2.
Copying speed 50 copies/min. (A4 (8-1/2" x 11"))
(at 100% copy ratio) 35 copies/min. (A4R (8-1/2" x 11"R))
29 copies/min. (B4 (8-1/2" x 14"))
25 copies/min. (A3 (11" x 17"))
Continuous copy Max. 999 copies; subtractive counter
First-copy time* Approx. 4.3 sec.
Warm-up time Less than 150 sec.
Copy ratio Variable: 25 to 400% in 1% increments, total 376 steps
(can be set in the horizontal and vertical directions
independently)
Fixed presets: 25%, 50%, 70%, 81%, 86%, 100%, 115%, 122%,
141%, 200%, 400% (25%, 50%, 64%, 77%, 95%, 100%, 121%,
129%, 141%, 200%, 400%)
Exposure system Document glass: Moving optical source (stationary platen) with
automatic exposure function
RSPF: Moving original
Copy paper feed Two paper trays with automatic paper feed (500 sheets each);
one bypass tray with 50-sheet automatic feed capability
Fusing system Heat rollers
Developer system Magnetic brush development
Light source Xenon lamp
Resolution Scan: 400 dpi
Output: 600 dpi
Gradation Scan: 256 levels
Output: 2 levels (normal copying)
Required power supply Local voltage ±10% (For this copier’s power supply requirements,
see the name plate located on the left hand side at the rear corner of
the copier.)
* When the copier is in the noise level reduce mode, the first copy time will be several seconds longer.
SPECIFICATIONS