Sharp AR-507 - Manual (Page 162)

8-22
CHAPTER
8
KEY OPERATOR PROGRAMS
Size Setting for [EXTRA]
The paper sizes in the paper trays (except an optional large capacity
tray) can be changed by the users. The copier senses the paper sizes
with the paper size indicators in the paper trays. If a paper size indicator
is set to [EXTRA] and this program is used, the copier can sense paper
sizes as selected on the setting screen.
When the “SIZE SETTING FOR [EXTRA].” key is pressed, the
following display will appear.
1. Select a paper tray on the touch panel.
2. Select a paper size for [EXTRA] setting.
To select a size of INCH series, press the “INCH” key and
select a paper size.
● Select the paper size which matches the paper to be loaded into
the paper tray.
● This setting can also be used for paper trays in an optional stand/
500-sheet paper drawer (AR-DE7).
3. Press the “OK” key.
Heavy Paper on the Bypass Tray
In this copier, copies are normally delivered face down. Special paper
including transparency film , however, cannot be delivered face down.
If this program is set, any paper placed in the bypass tray will be
regarded as special paper. Copies from the bypass tray will always be
delivered face up. If this program is not set, paper type in the bypass
tray can be specified. If plain paper is specified, copies will be delivered
face down.
To regard paper placed in the bypass tray as special paper,
press the check box of “HEAVY PAPER ON THE BYPASS
TRAY.” to display a check mark in the check box.
To enable selection of paper type placed in the bypass tray,
press the check box of this program again to clear the check
mark in the check box.
KEY OPERATOR PROGRAMS
SIZE SETTING FOR
[EXTRA].
PAPER TRAY
2 1
A3
B5
B4
B5R
A4
A5
A4R
AB INCH
3 4
OK
EXTRA
KEY OPERATOR’S GUIDE
Key operator programs