Initial charging and discharging of batteries, Setting the date and time – Siemens GIGASET C475 IP User Manual
Page 14
13
First steps
Setting up the handset for use
Gigaset C470-475 IP / EN for IM-Ost / A31008-xxxx-xxxx-x-xxxx / starting.fm / 18.12.07
Ve
rs
ion 2.
1,
08.0
1.20
07
For questions and problems see page 163.
Initial charging and discharging of batteries
If the handset is activated, the flashing battery icon
e in the top right of the display indi-
cates that the batteries are being charged.
During handset operation, the battery icon indicates the charge status of the batteries
(page 1).
The correct charge status can only be displayed if the batteries are first fully charged and
discharged through use.
¤
To do this, leave the handset in the charging cradle without interruption until the bat-
tery icon stops flashing in the display (around 5 hours).
¤
Once the batteries are fully charged, remove the handset from the charging cradle and
do not put it back again until the batteries are fully discharged.
Please note:
u
Always repeat the charging and discharging procedure if you remove the batteries from
the handset and reinsert them.
u
The batteries may warm up during charging. This is not dangerous.
u
After a while the charge capacity of the batteries will decrease for technical reasons.
Setting the date and time
The date and time must be set in order to have the correct time for incoming calls and to
be able to use the alarm clock and calendar.
If the date and time on the phone have not yet been set, the
§Time§
display key will appear.
Please note:
After the first battery charge and discharge, you may place your handset in the charging cradle after
every call.
Please note:
You will find explanations for the symbols and typographical conventions used in this user guide in
the appendix, page 174.
Please note:
The address of a time server on the Internet is stored on your telephone. The date and time are taken
from this time server provided that the base station is connected to the Internet and synchronisation
with the time server is activated (page 161). Manual settings are overwritten in this case.