Siemens GIGASET C475 IP - Manual (Page 106)

105
Using several handsets
Using a handset as a room monitor
Gigaset C470-475 IP / EN for IM-Ost / A31008-xxxx-xxxx-x-xxxx / T-NetBox_SAG-registration.fm / 18.12.07
Ve
rs
ion 2.
1,
08.0
1.20
07
Using a handset as a room monitor
If the room monitor is activated, a previously stored destination number is called as soon
as a set noise level is reached in the room.
You can save an internal or external number in your handset as the destination number.
The room monitor call to an external number stops after around 90 seconds. The room
monitor call to an internal number (handset) stops after approx. 3 minutes (depending on
the base station). During use as a room monitor, all keys are barred except for the end call
key a. The speaker of the handset is muted.
When the room monitor is activated, incoming calls to the handset are indicated without
a ringer tone and are only shown on the screen. The display and keypad are not illumi-
nated and advisory tones are also turned off.
If you accept an incoming call, the room monitor is suspended for the duration of the call,
but the function remains activated.
If you deactivate then reactivate the handset, the room monitor remains activated.
Activating the room monitor and entering the number to be called
v
¢
í Add. Features
¢
Room Monitor
¤
Change multiple line input:
Room M.:
Select On to activate.
Call to:
Press the display key §Edit§ and enter destination number.
External number:
¤
Enter number directly or press
s and select number from directory.
Only the last 4 digits are displayed.
¤
Save number with §Save§ .
Internal number:
¤
Press the display key §INT§ .
¤
Select handset with s or Call All (if you want to call all registered handsets) and
press §OK§ .
Warning!
– You should always check the operation of the room monitor before use. For example, test
its sensitivity. Check the connection if you are forwarding the room monitor to an external
number.
– When the function is switched on, the handset's operating time is severely reduced. If necessary,
place the handset in the charging cradle. This ensures that the batteries do not run down.
– Ideally the handset should be positioned 1 to 2 metres away from the baby. The microphone must
be directed towards the baby.
– The connection to which the room monitor is forwarded must not be blocked by an activated
answer machine.