Interphase Tech RAS Communications Controller 5536 - Manual (Page 94)

Firmware Management
74 Interphase Corporation
Firmware Management
The Firmware section of the WAN Adapters Setup dialog box
displays firmware information for the WAN card selected in
the Cards section. It displays the protocols you can use with
the card, and their status. You can view the firmware status,
reload the firmware, or change the firmware.
The firmware status is represented by a general LED color for
the firmware and individual LEDs for each protocol, as
follows:
LED Color General Firmware Individual Protocol LEDs
Red No firmware is found on the
disk for the current card. N/A
Gray Firmware is found but is not
loaded into the card. The protocol is inactive.
Yellow Firmware is running on the
card but differs from
firmware found on the disk
for this card. Changes to the firmware layer
have been applied, but have
not been loaded and saved to
the disk.
Green The firmware is running. The protocol is active.