Interphase Tech RAS Communications Controller 5536 - Manual (Page 107)

Chapter 5: Setting Up WAN Firmware and Hardware
5536 PRI RAS Communications Controller Users Guide 87
3. To set the speech coding law, select A Law for Europe
and Australia, or select
µ
Law (Mu law) for North
America and Japan.
4. Click OK.
5. Repeat Steps 1 through 4 for the digital modems of any
other installed 5536-DM RAS boards.
Saving WAN Setup Properties
Save any changes to WAN firmware, card, and port properties
as follows:
1. Apply the changes by clicking the Apply button.
2. Reload the firmware on the card by clicking the Load
button. Then follow the on-screen instructions.
3. After the properties have been loaded, click OK to save
the reloaded configuration and close the WAN Adapters
Setup dialog box.
The configuration software automatically finds the
relevant firmware for the board. It updates the registry
and dynamically updates the drivers.
4. To re-enable the RAS Server and RAS Port Manager
utility, stop and restart the services as follows.
a. From the Start menu, select Settings, and then
Control Panel. Then double-click the Services icon
to display the Services dialog box.
b. Select Remote Access Server from the list of
services, and click Stop.
c. When a message informs you that the RAS Port
Manager will also be stopped, click OK.