Interphase Tech RAS Communications Controller 5536 - Manual (Page 32)

Minimum System Requirements
12 Interphase Corporation
• If the ACE/Server grants the access, the communication
can continue with the Windows NT authentication
phase.
• If the ACE/Server refuses the access, the
communication is immediately broken. When the
connection is untrusted because of the passcode end-of-
delay, the remote client is not especially notified: the
failure is a connection failure. It is the client’s
responsibility to start the connection again.
The RAS support driver can manage secured multilink
connections as well. The SecurID authentication is processed
only for the primary link.
All the SecurID authentication successes or failures are
registered in the Windows NT Event log.
Minimum System Requirements
Following are the minimum system requirements for using this
board with Microsoft Remote Access Service (RAS):
• Intel
®
system running Windows NT Version 4.0
• PCI Bus architecture conforming to PCI Local Bus
Specification Revision 2.1
• Pentium processor at 133 MHz or faster
• 64 MB RAM (possibly 128 MB or more, depending on
your RAS configuration and usage)
• Hard disk with 6 MB free
• CD-ROM drive
• Single PRI version: One functional ISDN primary rate
interface for each board
• Dual PRI version: One or two functional ISDN primary
rate interfaces for each board