Interphase Tech RAS Communications Controller 5536 - Manual (Page 54)

Connector Pinouts
34 Interphase Corporation
Connector Pinouts
The following illustration of the board’s faceplate shows the
board’s connectors and connector pins:
Figure 3-5. Faceplate and Connector Pinouts
The board’s connectors follow the RJ48C specification.
For each connector, four LEDs display the status of the link (as
described in
Interpreting LEDs on page 118 ).
1
2
3
4
5
6
7
8
Pin
Tx out (tip)
Tx out (ring)
Rx in (ring)
Rx in (tip)
Signal
8
1
(RJ48C)
(RJ48C)
Port #1
(Port #1)
(Port #0)
Port #0
LEDs 5, 6, 7 & 8
LEDs 1, 2, 3 & 4
RJ48C Pinout