Interphase Tech RAS Communications Controller 5536 User Manual
Page 71
Chapter 4: Installing the Software
5536 PRI RAS Communications Controller Users Guide
51
For the Digital Modem RAS Support driver, the driver name in
the title bar is 5536 DM RAS Support. For the ISDN RAS
Support driver, the driver name is 553x ISDN RAS Support.
The contents of the dialog box are the same for both drivers.
The RAS support setup is done automatically. The RAS
Support General dialog box enables you verify RAS support
properties for the driver you are configuring.
N
OTE
If you need to set up additional card or port properties
before continuing, click the WAN Setup button to access
the WAN Adapters Setup dialog box. Then repeat the
appropriate steps in
Setting Up Card and Port Properties
.
RAS Support dialog boxes and setup procedures are described
in detail in
Setting Up RAS Support Properties on page 95
To complete the RAS Support setup:
1. If needed, change the Idle Timeout value from 0, which
disables the timeout function, to the number of seconds
of inactivity to allow before ending a connection.
2. If needed, check the SecurID support box to enable
additional filtering on SecurID authentication
information and change the Separator character if
necessary.
3. Click OK to confirm the displayed configuration.
One of the following messages appears, depending on
whether RAS is installed on your system: