4 ds command-line interface, 1 ds cli supported environments, 5 ds cli command- examples – IBM DS6000 User Manual
Page 189
Chapter 14. Metro Mirror interfaces
165
14.4 DS Command-Line Interface
Although the DS CLI will not run on a System z processor, it can be used to perform
operations on mainframe disks if you have a supported server environment (for example,
Windows XP). The DS CLI can be used to create scripts for setup and control of DS6000
functions. It is a flexible and powerful interface. The DS CLI commands are documented in
IBM System Storage DS6000: Command-Line Interface User´s Guide, GC26-7922.
14.4.1 DS CLI supported environments
The DS CLI is supported on the operating systems listed below, at the time of writing:
AIX
HP-UX
HP Tru64
Linux
Novell Netware
OpenVMS
OS/400®, i5/OS
Sun Solaris
Windows
For the most current list of DS CLI supported environments, refer to the interoperability
matrix, which is found at the IBM Products site at:
14.5 DS CLI command- examples
In this section we cover the most frequently used DS CLI commands in a Metro Mirror
environment, and provide examples of their usage. For most of these commands, you must
know some (or all) of the following information:
The serial number and device type of the source and target DS6000, identified by the -
dev
and
-remotedev
parameters.
– One way to get the serial number and device type is to use the
lssi
command.
– The serial number and device type will have the format
IBM.1750-1300247
, for
example.
The WWNN of the remote DS6000, identified by the
-remotewwnn
parameter. The WWNN
is also available using the
lssi
command.
The LSS numbers where the source and target volumes are.
– The
lslss
command displays all of the LSSs on the system.
– For a particular volume, the first two digits of the volume number represents the LSS.
For example, volume
D000
is located in LSS
D0
.
– LSS numbers are two-digit hexadecimal numbers.
Note: In order to run the job to refresh the VTOC of the secondary volume, the Metro
Mirror volume pair must first be deleted.
Note: Many of the examples that are presented here omit the
-dev
and
-remotedev
parameters because we specify them in the DS CLI profile. Using the profile can
save a significant amount of typing.