Invacare Force - Manual (Page 73)

SECTION 9—OPTIONS
Part No 1114850 73 Recumbent Handcycle Series
Adjusting the Handcycle Rack
Wheel Tray Bracket
NOTE: To properly secure the handcycle, the wheel tray bracket should be adjusted to sit against
the front wheel.
1. Remove the four mounting bolts and locknuts securing the wheel tray bracket to the
wheel tray.
2. Position the wheel tray bracket in the desired position.
3. Secure the wheel tray bracket to the wheel tray with the four mounting bolts and
locknuts.
4. If necessary, the wheel stop may be adjusted to one of three positions to sit against the
front wheel. To adjust the wheel stop, perform the following steps:
A. Remove the mounting bolt and locknut securing the wheel stop to the wheel tray
bracket.
B. Position the wheel stop in the desired mounting position.
C. Secure the wheel stop to the wheel tray bracket with the mounting bolt and
locknut.
Rear Wheel Bar Brackets
NOTE: To properly secure the handcycle, the rear wheel bar brackets should be adjusted to sit
against the rear wheels.
1. Loosen the two screws securing the rear wheel bar bracket to the rear wheel bar.
2. Adjust the rear wheel bar bracket in/out until they sit against the rear wheel.
3. Secure the rear wheel bar bracket to the rear wheel bar with the two screws.
4. Repeat STEPS 1‐3 for the opposite side if necessary.
Rear Wheel Bar
NOTE: To properly secure the handcycle, the rear wheel bar should be adjusted so the rear wheels
sit in the rear wheel bar brackets.
1. Remove the two mounting bolts and locknuts securing the rear wheel bar to the wheel
tray.
2. Position the rear wheel bar to one of three mounting positions on the wheel tray.
3. Secure the rear wheel bar to the wheel tray with the two mounting bolts and locknuts.