Invacare Force - Manual (Page 58)

SECTION 8—SERVICE PROCEDURES
Recumbent Handcycle Series 58 Part No 1114850
Parking Brake
ƽ WARNING
Replacement of the parking brake MUST be performed by a qualified technician.
FIGURE 8.10 Adjusting/Replacing the Parking Brake
Replacing Seat Upholstery
ƽ WARNING
Upholstery MUST be inspected before each use. Exposure to moisture (i.e. - wet
weather or puddles) will damage fastening straps/flaps/strips. DO NOT operate
handcycle if upholstery is wet or damaged, otherwise severe injury may occur.
NOTE: For this procedure, refer to
FIGURE 8.11.
1. Remove seat cushion and back
upholstery from chair.
2. Unlatch the four fastening flaps that
secure the seat upholstery to the seat
frame.
3. Remove the existing seat upholstery.
4. Install the new seat upholstery making
sure that the three fastening flaps that
are in close proximity to one another
are to the rear of the seat frame.
5. Secure the four fastening flaps together.
6. Reinstall back upholstery and seat
cushion onto chair.
FIGURE 8.11 Replacing Seat Upholstery
Rim of Wheel
Brake Pad
Mounting Nut
Stop Button
Hex Nut
Adjuster Barrel
Towards Front of
Chair
Large Strap
Toward
Rear of Seat
Frame
Three Seat Upholstery
Fastening Straps Towards
Rear of Seat Frame
Back
Upholstery