Removing road crown compensator, Adjusting road crown compensator – Invacare Force User Manual
Page 51
SECTION 8—SERVICE PROCEDURES
51
Removing Road Crown Compensator
1. Remove the locknut securing the fork end of the road crown compensator to the fork
bolt.
2. Remove the fork end of the road crown compensator from the fork bolt.
3. Remove the bolt and spacer securing the frame end of the road crown compensator to
the frame.
Adjusting Road Crown Compensator
NOTE: This adjustment is made for handcycling on crowned roads or in heavy winds.
1. Rotate the fork end of the road crown compensator to adjust the length. Clockwise ‐
shortens the road crown compensator and pulls the front wheel to the left.
Counterclockwise ‐ lengthens the road crown compensator and pushes the front
wheel to the right.
FIGURE 8.3 Installing/Removing/Adjusting the Road Crown Compensator
Adjustment
Fork End
Road Crown Compensator
Installed
Fork
Road Crown
Compensator
Frame
Removed
Fork Bolt
Road Crown
Compensator
Frame End
Fork End
Bolt
Locknut
Frame
Mounting
Hole
Frame
Spacer