Horizontal handles/delrin handles, Tri-pin quad handles, V or s crank handles – Invacare Force User Manual
Page 64: Installing hand crank handles, Installing v/s crankarm handles
SECTION 9—OPTIONS
64
Installing Hand Crank Handles
NOTE: For this procedure, refer to FIGURE 9.9.
Horizontal Handles/Delrin
Handles
1. Secure handle to hand crank with the
screw (Detail “A”).
2. Remove the screw to remove handle
from handcrank.
Vertical Handles
1. Position handle onto crank (Detail “B”).
2. Tighten set screw to secure handle to
crank.
3. Reverse STEPS 1‐2 to remove handle.
Tri-pin Quad Handles
1. Remove/install tri‐pin quad handles.
Refer to Vertical Handles on page 64
2. Loosen socket screws to adjust handle
position (Detail “C”).
3. Tighten socket screws to secure
handles in desired position.
V or S Crank Handles
Replacement/installation of V or S crank
handles should be done by a qualified
technician.
FIGURE 9.9 Installing Hand Crank Handles
Installing V/S Crankarm Handles
For Models Made Before 7/12/07
ƽ WARNING
Failure to install handle assembly properly could result in injury.
It is recommended to inspect this assembly prior to and after each use.
NOTE: For this procedure, refer to FIGURE 9.10 on page 65.
1. Secure the handle to the crankarm housing using the bolt, spacer, and two bearings.
Horizontal Handle
DETAIL “A” - HORIZONTAL
HANDLES/DELRIN HANDLES
Hand Crank
Screw
Vertical Handle
DETAIL “B” - VERTICAL HANDLES
Hand Crank
Set Screw
Tri-Pin
Quad
Handle
DETAIL “C” - TRI-PIN HANDLES
Socket
Screw