Invacare 1035966 - Manual

NOTE: Check all parts for shipping damage and test be-
fore using. In case of damage, DO NOT use. Contact the
dealer / Invacare for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
safe installation of the Wheelchair Tray:
WARNING
DO NOT assemble or use this equipment with-
out first reading and understanding this instruc-
tion sheet. If you are unable to understand the
Warnings, Cautions or Instructions, contact a
healthcare professional, dealer or technical
personnel if applicable before attempting to in-
stall this equipment - otherwise, injury or dam-
age may occur.
Any worn or damaged hardware MUST be re-
placed.
After installation, repair or service and BEFORE use,
make sure all attaching hardware is securely tight-
ened - otherwise, injury or damage may result.
INSTALLING WHEELCHAIR TRAY
(FIGURE 1)
1. Remove the two (2) phillips screws from the arm pad.
2. Slide the bracket support tube into the bar guide as-
sembly as shown in FIGURE 1.
NOTE: The bracket of the bar guide assembly and the
tube of the bracket support should be positioned towards
the outside of the wheelchair frame.
3. Loosely install phillips screw through the bracket sup-
port tab, wheelchair frame and arm pad.
4. Position the bar guide assembly tab to align with the
mounting hole of the wheelchair frame.
5. Loosely install phillips screw through the bar guide
assembly, wheelchair frame and arm pad.
6. Repeat STEPS 1-5 for opposite side.
7. Remove protective paper from the tray.
8. Position the tray bracket on the wheelchair tray BOT-
TOM as shown in FIGURE 1.
NOTE: For wheelchairs over 18-inches wide, reverse the
tray brackets with the sockets positioned towards the out-
side of the tray.
9. Install carriage bolts through TOP of wheelchair tray
and tray bracket.
10. Secure the tray bracket to the tray with the two (2)
wing nuts.
11. Repeat STEPS 8-10 for opposite side.
12. Insert the tray support bar into the tray bracket and
hand tighten the socket screw.
13. Insert the tray support bars into the bracket supports
at the desired position.
14. Securely tighten the four (4) phillips screws.
15. Center the tray on the wheelchair.
NOTE: If the tray will not center, adjust tray support bars.
16. After making sure the tray is centered on the wheel-
chair, securely tighten the socket screws.
Wing Nuts
Carriage Bolts
Tray
Bracket
Arm Pad
Phillips Screws
Bracket Support
and Tube
Wheelchair Tray
Tray
Support
Bars
FIGURE 1 - INSTALLING WHEELCHAIR TRAY
Bar Guide
Assembly
Bracket
Tab
Socket Screw
Wheelchair
Frame
Tab
WHEELCHAIR TRAY
Assembly, Installation, and Operating Instructions
Model No. 1300, 1035965, and 1035966
Invacare Corporation www.invacare.com
One Invacare Way
Elyria, Ohio USA
44036-2125
800-333-6900
Technical Support
800-832-4707
Invacare is a registered trademark of Invacare Corporation
© 1999 Invacare Corporation
Form No. 84-41 P/N 1023704 Rev. B (1) - 11/99