Invacare Force - Manual (Page 40)

SECTION 6—RIDING POSITION
Recumbent Handcycle Series 40 Part No 1114850
Adjusting Back Angle - XLT Gold
NOTE: For this procedure, refer to FIGURE 6.10.
1. Loosen, but DO NOT remove, the two socket screws located in the seat angle
adjustment clamp.
2. Perform one of the following:
• Increasing Back Angle ‐ While pushing down on the back support tube, push the
back down to the desired position.
• Decreasing Back Angle ‐ While lifting up on the back support tube, pull the back
upward to the desired position.
3. Securely tighten the two socket screws located in the seat angle adjustment clamp.
FIGURE 6.10 Adjusting Back Angle - XLT Gold
Back Support Tube
Socket
Screw
Adjustment Holes
NOTE: Wheel not shown for clarity.