Replacing back upholstery, Replacing wide back upholstery, Replacing narrow back upholstery – Invacare Force User Manual
Page 59: Refer to replacing back upholstery
SECTION 8—SERVICE PROCEDURES
59
Replacing Back Upholstery
ƽ WARNING
Upholstery MUST be inspected before each use. Exposure to moisture (i.e. - wet
weather or puddles) will damage fastening straps/flaps/strips. DO NOT operate
handcycle if upholstery is wet or damaged, otherwise severe injury may occur.
Replacing Wide Back Upholstery
NOTE: For this procedure, refer to
FIGURE 8.12.
1. Unlatch the two fastening flaps that
secure the bottom of existing back
upholstery to the back canes.
2. Unlatch the top of the existing back
upholstery.
3. Lift up on the existing back upholstery
and remove from the handcycle.
4. Install the new back upholstery onto
the handcycle.
5. Securely latch the fastening flaps on the
bottom of the new back upholstery to
the back canes.
FIGURE 8.12 Replacing Wide Back
Replacing Narrow Back
Upholstery
NOTE: For this procedure, refer to
FIGURE 8.13.
NOTE: Pull the back cushion off the back
frame.
1. Align the fastening strips on the back
frame with the fastening strips on the
new back cushion.
1. Press the back cushion firmly against
the back frame to secure.
FIGURE 8.13 Replacing Narrow Back
Fastening
Flap
Back Upholstery
Fastening
Flap
Back Cane
Back Cushion
Back
Frame
Fastening
Strips
Fixed Seat
Narrow Back
Adjustable Seat
Narrow Back
Back
Frame
Fastening
Strips