Invacare Force - Manual (Page 41)

SECTION 6—RIDING POSITION
Part No 1114850 41 Recumbent Handcycle Series
Adjusting Back Height - Wide Back Option Only
NOTE: For this procedure, refer to FIGURE 6.11.
NOTE: This procedure applies to Top End XLT models with wide back option only.
1. Remove the back upholstery from the handcycle. Refer to Replacing Back Upholstery
on page 59.
ƽ WARNING
Push pin MUST protrude through hole in back cane.
Ensure that both back cane inserts are at the same height before reassembling the
chair.
2. Press the push pin on the back cane insert tube in and adjust the back height to one of
three heights depending on original back height.
3. Reinstall the back upholstery onto the handcycle. Refer to Replacing Back Upholstery
on page 59.
FIGURE 6.11 Adjusting Back Height - Wide Back Option Only
Back Cane
Push Pin
Back Cane Insert