Section 5—operation, Riding the handcycle – Invacare Force User Manual
Page 26
SECTION 5—OPERATION
26
SECTION 5—OPERATION
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Riding the Handcycle
ƽ WARNING
Before operating the handcycle, review the General Guidelines on page 12 in of this
manual.
DO NOT operate the handcycle if the hand crank obstructs your view. If the hand
crank obstructs your view, adjust the height before using the handcycle -
otherwise injury or damage may occur.
NOTE: For this procedure, refer to FIGURE 5.1 on page 27.
1. Engage the parking brake, if equipped. Refer to Using Parking Brake on page 30.
2. Transfer into the handcycle. Refer to Transferring Into/Out of the Handcycle on
3. Ensure that the hand crank is not obstructing your view. Refer to Adjusting Hand
4. Ensure the footrest is adjusted properly. If necessary, adjust the footrest. Refer to
Replacing/Adjusting the Footrest and Leg Guard on page 32.
NOTE: Footrest should be adjusted so that when seated with feet in the footrests, there is a slight
bend at the knee.
5. Ensure the seat is adjusted properly. If necessary, adjust the seat. Refer to Adjusting
Seat Fore/Aft ‐ All Models Except XLT Gold and Top End Force on page 36 or
Adjusting Seat Height ‐ All Models Except XLT Gold and Top End Force on page 38.
NOTE: Seat should be adjusted so that when seated with feet in the footrests, there is a slight bend
at the knee and a slight bend at the elbow when the hand crank is furthest away.
6. If installed, release the parking brake. Refer to Using Parking Brake on page 30.
ƽ WARNING
At least one hand MUST be on the hand crank assembly at all times. Otherwise,
injury or damage may occur.
7. Place at least one hand onto the hand crank pedals.
NOTE: The hand crank assembly is used for propelling and steering of the handcycle.