Invacare Force - Manual (Page 65)

SECTION 9—OPTIONS
Part No 1114850 65 Recumbent Handcycle Series
2. Firmly tighten the bolt.
NOTE: Handle should spin freely with minimal play. If handle does not spin freely make sure the
spacer is firmly in place. If handle still does not spin freely, contact Invacare.
FIGURE 9.10 Installing V/S Crankarm Handles - For Models Made Before 7/12/07
For Models Made After 7/12/07
ƽ WARNING
Failure to install handle assembly
properly could result in injury.
It is recommended to inspect this
assembly prior to and after each use.
NOTE: For this procedure, refer to
FIGURE 9.11.
1. Secure the handle to the crankarm
housing using the set screw and
locknut.
NOTE: Use the right handle, the handle with a
mounting post, with the right crankarm and
left with left crankarm. The right crankarm has
a flange at the base of the crankarm. The left
crankarm does not.
2. Firmly tighten the locknut.
NOTE: Handle should spin freely with
minimal play. If handle does not spin freely,
contact Invacare.
FIGURE 9.11 Installing V/S Crankarm
Handles - For Models Made After 7/12/07
Crankarm
Handle
Bearing
Spacer
Bolt
Bearing
Crankarm
Housing
Crankarm
Handle
Locknut
Left
Crankarm
Flange
Right
Crankarm
DETAIL “A” - HANDLE
REPLACEMENT
Crankarm Housing
Set
Screw
DETAIL “B” - CRANKARM
ORIENTATION
Left
Handle
Right
Handle
Mounting
Post