Invacare Force - Manual (Page 39)

SECTION 6—RIDING POSITION
Part No 1114850 39 Recumbent Handcycle Series
Adjusting Back Angle - All Models Except XLT Gold and
Top End Force
NOTE: For this procedure, refer to FIGURE 6.9.
1. If installed activate parking brake.
2. Loosen, but DO NOT remove the four rear socket screws that secure the seat frame to
the handcycle frame.
NOTE: There are two socket screws on the right and left side of the handcycle.
3. Loosen, but DO NOT remove the hex bolts and locknuts that secure the two seat angle
adjustment clamps to the rear seat supports.
NOTE: There is one clamp on the right and left side of the handcycle.
4. Perform one of the following:
• Increasing Back Angle ‐ While lifting up on the back support tubes, pull the seat
upward to the desired position.
• Decreasing Back Angle ‐ While pushing down on the back support tubes, push the
seat down to the desired position.
5. Tighten the four socket screws that secure the seat frame to the handcycle frame
securely.
6. Tighten the hex bolts and locknuts that secure the two seat angle adjustment clamps
to the rear seat supports securely.
FIGURE 6.9 Adjusting Back Angle - All Models Except XLT Gold and Top End Force
Seat Angle Adjustment Clamps
Back Support Tube
Rear Socket Screws
Handcycle Frame