Invacare Force - Manual (Page 66)

SECTION 9—OPTIONS
Recumbent Handcycle Series 66 Part No 1114850
Installing Gloves
NOTE: For this procedure, refer to FIGURE 9.12 on page 66.
1. Wrap palm loop around horizontal handle (using top slot only) and secure to glove.
2. Run glove loop through bottom slot on palm and over back of hand until tight. Secure
glove loop to back of glove.
3. Reattach glove strips to back of glove.
FIGURE 9.12 Installing Gloves
Mountain Drive Transmission Option
ƽ WARNING
DO NOT shift the mountain drive transmission option under load (i.e. using a high
gear to start the handcycle in motion or to climb a hill, etc.). Shifting the mountain
drive transmission option under load will damage the internal workings of the
mountain drive option and will void the warranty.
NOTE: For this procedure, refer to FIGURE 9.13 on page 66.
Switching to Mountain Drive Transmission Option
1. Perform one of the following:
• Switching Mountain Drive
Transmission Option On ‐ Push in
the gear shift button in the middle
of the right side of the hand crank
while the option is under no load.
• Switching Mountain Drive
Transmission Option Off ‐ Push the
gear shift button on the left side of
the hand crank in while the option
is under no load.
FIGURE 9.13 Mountain Drive
Transmission Option
Mountain Drive Transmission Option Maintenance
The mountain drive transmission option should be maintained by a qualified technician
according to the manufacturerʹs instructions included with the handcycle.
Glove
Glove
Strip
Top Slot
Palm
Loop
Palm Loop Secured to Glove
Horizontal Handle
Bottom Slot
Glove
Strip
Glove Loop
Gear Shift
Button
Hand
Crank