Section 9—options, Installing rear safety light – Invacare Force User Manual
Page 60
SECTION 9—OPTIONS
60
SECTION 9—OPTIONS
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Installing Rear Safety Light
ƽ WARNING
Operation of the handcycle is subject to
all traffic rules and regulations. (This
may include the use of a safety light and
reflectors for dusk/night riding.)
NOTE: For this procedure, refer to
FIGURE 9.1.
Batteries
1. Remove the lens cover.
2. Insert the AAA batteries with correct
polarity (+ or ‐).
3. Reinstall lens cover.
FIGURE 9.1 Installing Rear Safety Light
Mounting the Safety Light
1. Remove the set screw from the clamp on the safety light.
2. Position the clamp onto the rear seat post.
3. Install the set screw into the clamp and tighten securely.
Operating the Safety Light
1. Press GREY button to turn safety light on/off.
2. Remove lens cover and slide switch back and forth for pulse or constant mode.
Rear Seat Post
Set Screw
NOTE: Rear wheels removed for clarity.
Clamp
Lens
Cover
Safety Light