Invacare Force - Manual (Page 70)

SECTION 9—OPTIONS
Recumbent Handcycle Series 70 Part No 1114850
3. Using the fork clamp and two socket screws, secure the bottom of the plate to the
frame.
4. While inserting the lower threaded post into the tab, position the dampener clamp
around the handcycle frame.
5. Using two socket screws, loosely secure the dampener clamp to the handcycle frame.
6. Using a locknut, secure the steering dampener to the dampener clamp.
7. Install the front wheel. Refer to Installing the Front Wheel on page 71.
8. Ensuring the front wheel and dampener clamp are inline with the handcycle frame,
securely tighten the two socket screws securing the dampener clamp to the handcycle
frame.
9. Test drive handcycle, if handcycle pulls to the left or right adjust the steering
dampener. Refer to Adjusting Steering Dampener on page 52.
FIGURE 9.16 Removing/Installing the Fork - XLT Gold, and Top End Force Equipped with
Steering Dampener
Removing/Installing the Front Wheel - XLT Gold, XLT
Pro and XLT with Speed Cassette Chain
NOTE: For this procedure, refer to FIGURE 9.17 on page 71.
Removing the Front Wheel
1. Open the quick‐release lever securing the front wheel to the fork (Detail ʺAʺ).
2. Loosen the knob on the opposite side of the quick‐release lever.
3. Remove the wheel from the fork.
4. Remove the chain from the front wheel.
Dampener Clamp (Tab)
Lower Threaded Post of
Steering Dampener
Handcycle Frame
Dampener Clamp
Fork Clamp
Fork Clamp
Locknut
Socket Screws
Fork