Invacare Force - Manual (Page 45)

SECTION 7—WHEELS
Part No 1114850 45 Recumbent Handcycle Series
Adjusting Toe In/Toe Out
1. Loosen, but DO NOT remove the socket screws and clamps that secure camber inserts
to the camber bar (Detail ʺAʺ).
2. Slowly rotate the camber insert until the rear wheels are approximately in a straight
line.
3. Securely tighten the socket screws and clamps that secure the camber inserts to the
camber bar.
4. Measure the distance between the center lines at the rear and front of the rear wheels
at approximately 12 inches from the ground/floor. Refer to Determining Toe In/Toe
Out on page 44.
5. Repeat STEPS 1‐4 until the toe in/toe out measurement is less than 1/8‐inch (for
maximum rollability).
Replacing Camber Inserts
NOTE: For this procedure, refer to FIGURE 7.4.
1. Loosen, but DO NOT remove the socket screws and clamps that secure the camber
inserts to the camber bar.
2. Remove the existing camber insert from the camber bar.
3. Install the new camber insert into the camber bar.
4. Adjust the toe in/toe out of the handcycle. Refer to Determining/Adjusting Toe In/Toe
Out on page 44.
FIGURE 7.4 - Replacing Camber Inserts
Clamp
Camber Bar
Socket Screw
Camber
Insert
Frame