Invacare Force - Manual (Page 69)

SECTION 9—OPTIONS
Part No 1114850 69 Recumbent Handcycle Series
FIGURE 9.15 Removing/Installing the Fork - Travel Ready XLT PRO Equipped with Road
Crown Compensator
Removing/Installing the Fork - XLT Gold, and Top End
Force Equipped with Steering Dampener
NOTE: For this procedure, refer to FIGURE 9.16 on page 70.
Removing the Fork
1. Remove the locknut securing the steering dampener to the dampener clamp
(Detail ʺAʺ).
2. Remove the two socket screws securing the dampener clamp to the handcycle frame.
3. Remove the dampener clamp from the handcycle frame and the lower threaded post
of the steering dampener.
4. Remove the two socket screws from the fork clamp.
5. Remove the plate from the top of the fork.
6. Remove the fork from the frame.
7. Remove the front wheel from the fork.Refer to Removing the Front Wheel on page 70.
Installing the Fork
1. Position the fork onto the frame.
2. Position the plate on to the fork.
Fork Clamp
Plate
Socket
Screws
Fork Fork
Clamps
Nut
Fork Bolt
Road Crown Compensator
Frame
Fork
Clamp