IBM SY27-0345-06 - Manual (Page 93)

10. Store the antistatic bag in a safe place. You will need this if you remove the
adapter from the IBM 2210.
Removing the 4-Port Dial Access Modem Card
To remove the 4-port Dial Access Modem Card from the Dial Access Adapter:
1. Remove the adapter from the IBM 2210 as described in “Removing the
Optional Adapter” on page 4-38.
2. Using a nut driver, remove the three screws securing the 4-port Dial Access
Modem Card.
3. Grasp the 4-port Dial Access Modem Card upgrade by the connector next to
the words PRESS HERE TO INSERT.
4. Lift and wiggle the connector until the 4-port Dial Access Modem Card plug
comes free of the Dial Access Adapter socket.
5. Replace the 4-port Dial Access Modem Card as described in “Upgrading the
4-Port Dial Access Adapter Using the 4-Port Dial Access Modem Card Feature”
on page 4-42, if desired.
6. Reinstall the Dial Access Adapter as described in “Installing Optional Adapters”
on page 4-36.
Chapter 4. Removal and Replacement Procedures 4-43