IBM SY27-0345-06 - Manual (Page 90)

8
Verify that the IBM 2210 is functioning correctly by using “MAP 0210: Verify
Operation” on page 2-23.
Removing the EIA 232 Service Port Feature in Models 14T and 24x
1
Remove the cover from the IBM 2210 as described in “Cover” on page 4-2.
2
Remove the two screws that secure the EIA 232 Service Port Feature to the
IBM 2210 frame.
3
Remove the Philips-head screw that attaches the middle of the EIA 232
Service Port Feature to the standoff on the system board.
4
Remove the EIA 232 Service Port Feature connection from the system board.
5
Lift the EIA 232 Service Port Feature out of the IBM 2210 chassis.
Installing the 14.4 Kbps Modem Port Feature in Models 14T and 24x
Figure 4-42. Installing the 14.4 Kbps Modem Port Feature
1
Remove the cover from the IBM 2210 as described in “Cover” on page 4-2.
2
Remove the blank Service Port faceplate by unscrewing the two screws.
3
Save the faceplate and screws.
4
Insert the 14.4 Kbps Modem Port Feature connection into the connector on
the system board.
4-40 2210 Service and Maintenance