beautypg.com

IBM SY27-0345-06 User Manual

Page 69

background image

Power Supply

Removing the Power Supply for 12x Models

Figure

4-23. Connections to the Power Supply (12x Models)

1

Remove the connector to the system board (A) by pulling out the retaining
clips with your fingers or a screwdriver and then rocking the connector from
front to back as you pull up.

2

Remove the connector to the ac power source (B).

3

Remove the spade lug terminal ground for the ac power source (C), using
needle-nose pliers.

Chapter 4. Removal and Replacement Procedures

4-19