Minolta Scanner Mode - Manual (Page 303)

15 Troubleshooting
15-10 Scanner Mode
IP address faxing
Internet fax receptions
Problem Cause Remedy
Page
referen
ce
Transmission
is not possible. The connections are incorrect. Check the LED indicator on
the hub and check the
connections. -
Since the image data is too
large, a timeout occurred at
the receiving end. • Increase the timeout setting
on the receiving end.
• Decrease the size of the
image data, and then try
sending it again.
-
The settings necessary for the
device are not registered. Specify the necessary
network settings. p. 3-3
The LAN cable is damaged. Replace the LAN cable. -
Other causes Touch [Com.] on the Job List
screen to check the details of
the transmission error, and
then refer to the table of error
codes. p. 8-40,
p. 15-3
Problem Cause Remedy
Page
referen
ce
Reception is
not possible. The connections are incorrect. Check the LED indicator on
the hub and check the
connections. -
The setting to not
automatically check for new e-
mail messages has been
specified. Specify a time interval for
automatically checking for
new e-mail messages. p. 3-1
The settings necessary for the
device are not registered. Specify the necessary
network settings. p. 3-1
The same POP3 user name is
being used by a different e-
mail application or another
user. Do not use the same POP3
user name that is used by a
different e-mail application. -
The LAN cable is damaged. Replace the LAN cable. -