Minolta Scanner Mode - Manual (Page 260)

Specifying Management Settings 13
Scanner Mode 13-41
13.12 Specifying Report Output Settings
The procedure for specifying report settings, which are set by the
administrator, is described below.
Report settings
Specifying the setting for the “TX Report” parameter
1 Touch [Admin. 1], and then touch [Report Settings].
❍ Refer to “Displaying the Administrator Management screen” on
page 13-11.
2 Touch [TX Report].
• TX Report: Select how to output the report showing the
transmission result.
The factory setting is “Single destination : If TX
Fail, Multiple destination : If TX Fail”.
• Activity Report: Specify whether or not to automatically output
the activity report with every 50 communications.
The factory setting is “ON”.